Recent Entries
WOODSMITH: Routing a 30° Chamfer
SHOPNOTES: Digital Set-up Gauge
WOODSMITH: Shop-Made Bench Dogs
WOODSMITH: More Leverage on Clamps
SHOPNOTES: Portable Assembly Station
WOODSMITH: Band Clamp Corner Protection
Archives
Related Sites
June 26, 2008
WOODSMITH: Routing a 30° Chamfer
On a recent project, I wanted to rout a 30-degree chamfer on the edge of a workpiece. But my chamfer bit (and almost all chamfer bits) will only cut a 45-degree bevel. To see my solution, click the following link:
Continue reading "WOODSMITH: Routing a 30° Chamfer"
